![]() Of course if you are set up for metric dimensions, just type the numbers separated either by a semi-colon or a comma depending on where in the world you’re located. No need to type in the inch symbol or the dash following the feet designation. If you are activating the rectangle tool, then type the width dimension separated by a comma from the length dimension thus: 25’6,15’. Just select the tool you want to activate, whether it be the line tool, the rectangle tool, or the tape measure tool and just type your desired dimension after making your selection. You do not type into the Value Control Box (VCB) - what you have referred to as the “measure” box. The videos can be found HERE - CLICK THIS. SketchUp is actually much easier to learn and use than Vectorworks IMO, so you should be able to achieve some skill with the software with little difficulty. ![]() ![]() Using the introductory videos to help you get up to speed with the program.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |